Inserts

[203ntyp]

I noticed most on this site use Goat Tuff for fletching. I was wondering what's the best choice for setting inserts? I have used hot glue & fletch tite but still have some come out when pulling shafts out of a target. Any suggestions would be greatly appreciated.

 

[timekiller]

I use the two part epxoy that come with the Easton shafts and inserts when I buy them, and I've never had one come out.

 

[Steve-O]

I have used pine ridge archery glue for 5 yrs now and fletched dozens of arrows as well as installed inserts with no problems.

 

[Iowabowtech]

A good majority of the insert adhesives contain an active ingredient called "cyanoacrylate". So what you're dealing with in many cases is regular old superglue with an archery company's name on the front just to make you feel confident that it's made especially for arrow building. /forum/images/%%GRAEMLIN_URL%%/grin.gif
If you use any such product, just be sure not to mess around too long AT ALL or you'll end up with an insert not fully seated and quite resistant to further movement. Not that I've done that. /forum/images/%%GRAEMLIN_URL%%/blush.gif

 

[gundog870]

dont use the heated stuff on ur carbons