Buck Hollow Sporting Goods - click or touch to visit their website Midwest Habitat Company

Jackhammers

Blaster

Blaster

PMA Member
If i want to shoot a couple of these into my Block, do i just have to wrap some floss around the blades? I think Shredder told me this?
 
Yep, and you will only have to shoot about two into it before you realize there is no need. They shoot in the same place as your FP. And, if the same rest is on that Switchy it will drive tacks.
grin.gif
 
That is what I did! Just tied some floss where those grooves are in the blades and after a couple shots I was done! They are great looking heads!
 
Does the floss replace the small rubberband that hold the blades together. Or does the floss not allow it to open and cut the crap out of the block target?

Thanks.

Dean
 
[ QUOTE ]
Or does the floss not allow it to open and cut the crap out of the block target?

[/ QUOTE ]

This is the correct answer...
grin.gif
 
As stated above, it should only take a shot or two or three before you realize it is not necessary.
 
Not trying to hi-jack the thread but I also had a question regarding these heads? When I'm hunting deer I usually slide the rubber o-ring as far back as possible while still allowing it to hold the blades in place. Does anyone else do this to maximize penetration? My bow is set in the low 60's and maybe it's not necessary but was curious if anyone else has tried this?
 
QDM,

I personally would not recommend sliding the O ring further back than the last groove. I shoot 55lbs and have had no problems. If you slide them behind the last groove you could possibly cause the blade to come open in flight resulting in an erratic arrow. You should have NO problems with penetration with the O rings in the groove closest to the shaft
waytogo.gif
 
You must log in or register to reply here.
Top Bottom