Liv4Rut
Active Member
Not sure if anyone has the Zink 360 or not but for me it didnt work all that great. The rope always slipped around the spool making it difficult to spin in less than ideal situations.
I tore it apart and took a 4ft section of 1/16th inch steel cable and wrapped it around the spool three full turns then I threaded it back through the holes towards the rope. I also put breach plug grease on the little peg that the spool sits on. I then clamped loops into the cable and tied my rope to it.
On the side of the spool, there is another port that it is threaded. Zvholk made up a rod that sticks into it and goes out about 5 inches then 90s down to the ground. It is used as an extra stake and support.
The end result is something that actually works great!! It works a 1000 times better than the original. :way: Just thought I would pass along the information.
I tore it apart and took a 4ft section of 1/16th inch steel cable and wrapped it around the spool three full turns then I threaded it back through the holes towards the rope. I also put breach plug grease on the little peg that the spool sits on. I then clamped loops into the cable and tied my rope to it.
On the side of the spool, there is another port that it is threaded. Zvholk made up a rod that sticks into it and goes out about 5 inches then 90s down to the ground. It is used as an extra stake and support.
The end result is something that actually works great!! It works a 1000 times better than the original. :way: Just thought I would pass along the information.